Whether you need one hole, a dozen holes, or patterns of holes, we can accomplish the task through our machine shop or tooling up a fixture to do the job, usually very economically.

We have the skill and relationship with an EDM wire cut shop to make most any hole required. We can create horn dies in a relatively short time frame to manufacture your job in a timely manner. There are times where plasma, laser or waterjet made holes are more practical over mechanical tooling methods due to properties, low quantity or leadtimes may dictate.

The center of the picture has an example of a copper can from .043" material 5" deep with the top holes accurate tighter than .005" centered with 2 outer diameter holes 180 degrees apart aligned with the bottom holes.

The picture here shows hole patterns on deep drawn parts needed after forming, side holes on compound and straight radius', key holes, round, square, rectangular, oblong, oversize, slotted, curved and tapped holes.