Holes & Hole Patterns Are Accomplished Accurately Through Our Tool & Die and Machining Capabilities

Holes & Hole Patterns Are Accomplished Accurately Through Our Tool & Die and Machining CapabilitiesWhether you need one hole, a dozen holes, or patterns of holes, we can accomplish the task through our machine shop or tooling up a fixture to do the job, usually very economically.

We have the skill and relationship with an EDM wire cut shop to make most any hole required. We can create horn dies in a relatively short time frame to manufacture your job in a timely manner. There are times where plasma, laser or waterjet made holes are more practical over mechanical tooling methods due to properties, low quantity or leadtimes may dictate.

The center of the picture has an example of a copper can from .043″ material 5″ deep with the top holes accurate tighter than .005″ centered with 2 outer diameter holes 180 degrees apart aligned with the bottom holes.

The picture here shows hole patterns on deep drawn parts needed after forming, side holes on compound and straight radius’, key holes, round, square, rectangular, oblong, oversize, slotted, curved and tapped holes.

Secure Credit Card Payments

This website features secure 128-bit SSL encrypted payments

This website is secure! Secured by PayPal

Follow Us

Contact Details

Fabricor Products, Inc.
22512 Curtis Place
California City, CA 93505
760-373-8292
760-373-8732 FAX

Contact Us